Although water often appears in the wrong place where the roof flows, it is recommended to start searching for damage from the place of water. It is also necessary to examine all neighboring sections of the roof. Do not wait for leaks. It is necessary to regularly carry out preventive checks of the roof, then it will be possible to detect and eliminate all the problems in a timely manner. The article proposes to consider the repair of the roof in the eagle made of tiles.
It is necessary to find the place of water flow, after which you can proceed to repair, by partial replacement of the roof:
Work should be started with the removal of damaged tiles. To do this, drive wooden wedges under the plates lying above. Then damaged tiles must be placed with a trowel and try to remove. If damage is noticed in several places, you need to start work from below, gradually moving up.
If a damaged roofing material is found under the removed tiles, then this area must be replaced. First you need to pull out the nails from the racks on the rafters, then a little hard cardboard must be made under these bars. It is fixed only on one side in relation to the damaged area.
Moving cardboard from the damaged area, a saw on the angle, the rails are cut on both sides. If the roofing material and the rails themselves are destroyed, the following points are executed: 5, 6.
Cut the damaged roofing material and put a patch with a knife, the size of a slightly more cut area, processing the edges with glue.
Measure the size of remote racks for the preparation of new ones, with a cross section like that of cut.
It is necessary to treat the rails with a solution for protection and nail using anti -corrosion nails to rafters.
Lay new tiles, starting from below and gradually moving up.
