Waveness appears due to non -compliance with the time to “fly off” linoleum. In this case, only a complete alteration will help.
Flaw and exfoliation of edges – as a rule, insufficient amount of glue or linoleum in these places was poorly smoothed and pressed. But these defects may appear due to wear of the coating and its aging. To eliminate swelling, it is sometimes enough to pierce the place of bloating with an awl and release air. Sometimes you have to make a cut carefully remove dust, dirt and remnants of old glue. Then a new layer of glue is applied, the cut place is pressed, the load is placed until the glue dries completely. Also act in the case of exfoliation of edges.
Scuffs arise due to intensive operation of the coating. You can eliminate this defect by installing a patch on this place. This is done as follows.
A worn place is cut out, dust is removed and the remains of the old glue are removed. It is advisable to primed this place. Then a suitable piece of linoleum is taken, in size slightly exceeding the size of a cut piece. Superimposed in the place of the future patch, is securely fixed and cut through together with the old coating. After that, a new piece is installed in place, naturally using glue.
