Wood furniture made of wood consist of a number of separate elements that are connected using non -gradible and collapsible details. It is here, in most cases, that various breakdowns occur. These defects must be eliminated immediately after detection, as they can lead to further damage, and the volume of repair will be much larger.
In case of damage to the back of the spike, the connection must be disassembled, cleaned of a layer of old and dried glue. To fasten wooden elements, as a rule, special carpentry glue in the form of granules and tiles is used. Delted into small pieces of tiles or granules are placed in a tin jar with cold boiled water. Glue should be there for about twelve hours. Then heating is carried out using a “water bath”, while you should constantly stir the glue with a chip. If a large amount of foam begins to form during heating in the bank, it must be carefully removed.
The readiness of the glue can be determined by its structure – the mass should become uniform and easily drain with a flat stream from the chip. If you get too liquid sticky mass, add several soaked tiles or glue granules to the jar. In the absence of carpentry glue, it can be successfully replaced by analogues: “station wagon”, “moment”, etc. The method of their use is described on the packaging. For wood, it is very good to use special synthetic glue, it is characterized by high frost – and water resistance. In no case do not forget about the impossibility of combining the carpentry glue and PVA.
When sifting, all existing dust, wood flour, as well as the formed sawdust should be removed. In the case of gaps of large sizes, you need to paste the spike of cotton or linen matter. The use of a very liquid adhesive mass, as well as a thin layer of its application leads to the fact that the seam becomes fragile. Such consequences are possible when using an too thick layer of glue.
To achieve the best result, you need to squeeze freshly launched compounds immediately after processing until they dry out. All kinds of loads, twisting from various ropes, etc. will help you with this. D. Be sure to ensure that the load distribution is uniform. In this state, the furniture should be at least 24 hours. After removing all the loads and twisted twisting, the product must be withstanded for another day before starting to use it.
In the case of a breakdown of the spike or some part of it, an immediate replacement of the broken area should be carried out. It is desirable to make it from the same material as the product itself. If the use of identical material is impossible, then it is best to use harder wood of wood. The new spike is glued into the socket after a two -day exposure.
If you are not entirely sure of your repair abilities, the best option would be the help of a specialist. Good luck!
