Do not panic if your brick pipe needs to be repaired. You can do this yourself without resorting to the help of specialists, which will save. Despite the fact that a brick pipe is a strong and durable structure, it sometimes requires repair work. This is due to the fact that the pipe for the removal of smoke is subject to some atypical factors. Especially damage to the external and internal parts of the pipes provoke harsh weather and precipitation.
Before starting repair work, it is very important that the chimney is completely cleaned. It is possible that for this operation it is worth buying overalls, t. To. After cleaning the chimney, the meaning of the phrase “as a chimney sweep” will become much more understandable and relevant than earlier. Thanks to this, it will be possible to detect all brick defects that need to be eliminated. Almost all brick pipes after a certain period need to be repaired by the crown of the region. It is important to know that the crown of the chimney should be very strong. If the crown is in order, then it will perfectly protect the internal laying from the solution from adverse natural factors, because smoke does not affect the internal structure of the chimney pipe. But you should not start the repair of the chimney if there are not at least basic knowledge in this matter.
To find out what defects on the pipe, you need to clean the surface and the territory adjacent to it from garbage and dust. That is, it is necessary to remove all the materials and dust, which can greatly interfere with the repair work of the chimney. If the dumped pieces of plaster were found at the same time, then they need to be removed immediately. For thoroughly cleaning the surface from damaged plaster, it is better to use a hammer and chisel, which will facilitate the work. To identify weak bricks, it is necessary to tap every brick with a chisel. Weak bricks must be replaced immediately and in no case do not use them again.
We take the packaging of the solution of the solution and pour into a bucket, but not a metal. Following the instructions you need to dilute the composition. The finished mixture is applied with a cell. With the help of a spatula and smoothly pressing the finished composition, you need to apply it with a cell. In this case, an excess solution is squeezed out and fills defective zones of the chimney pipe.
If the excess of the mixture forms, then they can easily be removed by the sharp side of the spatula. It is worth noting that the solution is applied only on one side of the new brick. After replacing the weak bricks, the remaining solution can be applied with a continuous layer to the surface of the pipe. The mixture dries very quickly and your chimney new can function!